Skip to main content
Shades Troubleshooting How to Change the Batteries...

Explore Knowledge Articles

How to Change the Batteries in your Palladiom Wire-Free Roller Shade

This article details changing batteries on your Lutron Palladiom Wire-Free Roller shades. 

 

This article is expected to take less than 5 minutes to complete.


Knowledge Article Contents:

Before You Begin

1: Expose and Open the Battery Door

2: Install New Batteries

3: Close the Battery Door to Power Up Shade

Related Articles


Before You Begin

Lutron recommends using Duracell Alkaline batteries in Lutron battery-operated shade products that require D-cell batteries.

For optimal battery life: Install new batteries. Do not mix old and new batteries. Do not install carbon-zinc or rechargeable batteries and do not mix battery types.

 

The sections below detail how to change the batteries on Palladiom Wire-Free Roller Shades. 


Section 1: Expose and Open the Battery Door

 

To access the Battery Door, grasp the fabric roll at the drive end and pull it out and away from the bracket.

Exposed the Battery Door on Palladiom Wire-Free Shades  

 

Push in, then up on the Battery Door to release it from the shade.

Opening the Battery Door on Palladiom Wire-Free Shades   

 

The open Battery Door allows access to the Battery Sleeve.

Open Battery Door and Exposed Battery Sleeve on Palladiom Wire-Free Shades  

 

The open Battery Door allows access to the Battery Sleeve.


Section 2: Install New Batteries

 

Use a finger to reach into the battery opening and pull out the Battery Sleeve. Pull the Sleeve all the way out and away from the shade.

Removing Battery Sleeve on Palladiom Wire-Free Shades  

 

Load the Battery Sleeve with NEW 1.5 Volt Alkaline, D-Cell batteries. Information on the sleeve indicates quantity and direction of the batteries. 

Installing New Batteries in Battery Sleeve of Palladiom Wire-Free Shades  

 

 

 Slide the loaded Battery Sleeve back into the shade as far as it will go.

Install New Batteries and Sleeve back into Palladiom Wire-Free Shades  

 


Section 3: Close the Battery Door to Power On the Shade

 

Swing the Battery Door up into the battery opening. Push is in and then down to secure it back in its original position.

Closed Battery Door on Palladiom Wire-Free Shades    

The shade button's LED indicator light will flash red/green three times when battery contact is made, confirming the shade is powered.


Related Articles

 

Click here for more help with Lutron Shade Blink Codes and Troubleshooting.