Skip to main content
RadioRA 3 System Design & Setup Cloud Connect/Places Introduction

Explore Knowledge Articles

Cloud Connect/Places Introduction

ka0PY0000001cxhYAA
000002936

Cloud Introduction

Lutron's new Cloud features allow installers to back up and restore the system's Project file, as well as make remote changes to the programming. This Guide will cover how to use Lutron Designer's Connect features and navigate the Places menu.

Contents:


How To View Projects In the Places Menu

When opening Lutron Designer and selecting your system type, it will load to the Places menu within Lutron Connect.

This will display all Places (Projects) you have been granted access to through the Cloud:

Places Menu

If you have a Project file saved on your computer from 23.4 or lower and is not in the list, there will be a button at the bottom of the list to open the local file.

  Browse Local button  

Within the Places menu, you can view the history of the Place and restore older versions if needed. To do so, tap the three dots next to the Open button and select View Version History

Note: This is only available within Lutron Designer and not the Lutron Connect Portal.

Version History option in the menu

In the Version History screen, you will be able to see Quick Access saves at the top, followed by all previous versions below. The three Quick Access saves will only appear if they apply for the system: Current Version, Last Conversion, and Last Transferred.

Version History menu

You can add up to 100 Characters of notes to each version by clicking on the Notes section. By default, they will only contain a basic reason for the new version such as the examples above.


How to Verify the Cloud Status of a Project within Designer

When opening a Place or local file, you will see a Cloud icon at the top right of the window showing the status of the Cloud and permissions.

Cloud Status of Remote Services

Clicking on the cloud will provide a description of the current cloud status:

  • Green Cloud with a Check Mark    GREEN: Remote services are enabled, and project cloud sync is good. 

  • Yellow Cloud with an Exclamation point   YELLOW: Remote services are enabled, but this account does not have permission to use them. Have the homeowner share access via Lutron App homeowner account settings, or have a programmer share access to the required Lutron account. 

  • Red Cloud with an X  RED: No internet connection on PC

  • Grey Cloud with an Exclamation Point  GRAY: Cloud sync is not enabled for this project. Can be changed in project settings.


How to Perform a Remote Transfer within Lutron Designer

With a Place connected to the Cloud with a Green status as noted above, you can perform a Remote Transfer to the system for Programming changes. Once all changes have been made, follow these steps to perform a Remote Transfer:

Select the Transfer tab in Designer. On the left there will be a Processor Connection Status to confirm the Processors are Online.

Transfer Tab while Remote

The status of the Processor can be one of the four:

  • Circled Blue Question Mark  Blue - This will be the initial status. It will remain this way until Designer can connect to the Processor, or fail to connect to the Processor.
  • Green Cloud with a Check Mark  Green - This means the Processor is online and ready for a Remote Transfer
  • Circled Red X  Red - This means Designer was unable to connect to the Processor. This will occur if the Processor is not connected to the internet.
  • Circled Yellow Exclamation point  Yellow - This means the Processor is not activated.

Once the Processor Connection Status is Green, then you can press Start Transfer to begin the Remote Transfer


Remote Diagnostics within Designer

Once connected to the cloud, you can use the Diagnostics tab in Designer to check on the system's status and if devices are responding.

For more information on this, please see our Troubleshooting with Lutron Designer Article.