Get help your way
How do I find my Model Number?
Do you have the original packaging?
-
If your product came in plastic packaging (a clamshell), you’ll find the model number on the front of the insert card, on the lower left corner. If your product came in a box, you’ll find the model number on the top of the box.
Most model numbers are 12-16 characters and start with a couple letters followed by a dash.
No packaging? No problem!
-
The product number is on a label on the side of the dimmer or switch.*
If you’ve already installed the dimmer/switch, turn off the electricity and then remove the wallplate. Unscrew and remove the wallplate adapter, then unscrew the dimmer/switch and pull it out of the wall until you can see the label.
*Please note: The product number for Ariadni/Toggler dimmers is not on a label. It’s located directly on the front of the dimmer on the top left, or right below the on/off toggle.
- Browse Components
-
Applied Filter: Sensors > LOS-CDT Dual Technology Ceiling Mount Occupancy > LOS-CDT-1000R
If you don't know your model number, try browsing for it here
- 1-Device DIN Panel
- 14" Low-voltage Enclosure
- 14" Low-voltage Enclosure
- myRoom 4-Module DIN Panel
- myRoom Low-Module Processor Panel
1-Device DIN Panel14" Low-voltage Enclosure14" Low-voltage EnclosuremyRoom 4-Module DIN PanelmyRoom Low-Module Processor PanelContact ClosureWallbox Contact Closure- Architrave Keypad
- Hospitality Pico
- Hospitality Pico Wireless
- Palladiom
- Pico Wired
- Pico Wireless
- seeTouch
- Signature Series
Architrave KeypadHospitality PicoHospitality Pico WirelessPalladiomPico WiredPico Wireless- QSWS2-1BI
- QSWS2-1BN
- QSWS2-1RLDI
- QSWS2-1RLDN
- QSWS2-2BI
- QSWS2-2BN
- QSWS2-2BRLI
- QSWS2-2BRLIRI
- QSWS2-2BRLIRN
- QSWS2-2BRLN
- QSWS2-2RLDI
- QSWS2-2RLDN
- QSWS2-3BDI
- QSWS2-3BDN
- QSWS2-3BI
- QSWS2-3BN
- QSWS2-3BRLI
- QSWS2-3BRLIRI
- QSWS2-3BRLIRN
- QSWS2-3BRLN
- QSWS2-5BI
- QSWS2-5BN
- QSWS2-5BRLI
- QSWS2-5BRLIRI
- QSWS2-5BRLIRN
- QSWS2-5BRLN
- QSWS2-7BI
- QSWS2-7BN
seeTouchSignature Series0-10 VDALINon-DimPhase Dimming16A Power Pack relay3 Wire FluorescentGRX-TVI Ten InterfaceMinimum LoadPhase AdaptiveSwitchingIndividual QSmyRoom QS LinkQS LinkGuest Room Edge ProcessorIntegration ApplianceQS sensor Module- LOS-CDT Dual Technology Ceiling Mount Occupancy
- LOS-CUS Ultrasonic Ceiling Mount Occupancy
- LOS-WDT Dual Technology Wall Mount Occupancy
- Radio Powr Savr Ceiling
- Radio Powr Savr Wall
- Wired Infrared Occupancy
LOS-CDT Dual Technology Ceiling Mount OccupancyLOS-CUS Ultrasonic Ceiling Mount OccupancyLOS-WDT Dual Technology Wall Mount OccupancyRadio Powr Savr CeilingRadio Powr Savr WallWired Infrared OccupancyBACnet Interface Software LicenseFan Coil Unit ControllerPalladiom Thermostat -
myRoom XC
-
#559 - Dimming Low-Voltage LED MR16 Lamps
-
#600 - Using Wired Sensors with Wireless Systems Through the Use of a WLCU301-CPN6814
-
#637 - NEMA SSL 7A DIMMER COMPLIANCE LIST Including Compliance With CA TITLE 24
-
#670 - Wiring Low-Voltage and Line-Voltage Using DIN Power Modules and Panels
-
#803 - Adaptive Power Module Troubleshooting Guide
-
Cleaning Recommendations for Lutron Products