WARNING: ELECTRIC SHOCK HAZARD.May result in Serious Injury or Death. Turn off power at circuit breaker or fuse before installing.
CAUTION:Use only with permanently installed fixtures with screw-in compact fluorescent, screw-in LED, halogen, or incandescent lamps. To avoid overheating and possible damage to other equipment, do not use to control receptacles, motor-driven appliances, or transformer-supplied appliances.
Install in accordance with all national and local electrical codes.
For indoor use only.
Fully wrap 14 AWG/12 AWG (1.5 mm2 /4.0 mm2) wires around the screw and tighten, or strip insulated 14 AWG (1.5 mm2) wires to 1/2 in (13 mm) and insert into the push-in terminals.
Tighten screw terminals securely to 5 in-lb (0.55 N•m).
Limited Warranty:
lutron.com/warranty. For a physical copy of warranty information, contact 1.844.403.1795 (Mexico: 1.888.235.2910).
Scroll down and click Accept to view installation information online, or click here to print an install guide. To receive a physical copy of the installation guide call 1.844.403.1795.
If your product came in plastic packaging (a clamshell), you’ll find the model number on the front of the insert card, on the lower left corner. If your product came in a box, you’ll find the model number on the top of the box.
Most model numbers are 12-16 characters and start with a couple letters followed by a dash.
No packaging? No problem!
The product number is on a label on the side of the dimmer or switch.*
If you’ve already installed the dimmer/switch, turn off the electricity and then remove the wallplate. Unscrew and remove the wallplate adapter, then unscrew the dimmer/switch and pull it out of the wall until you can see the label.
*Please note: The product number for Ariadni/Toggler dimmers is not on a label. It’s located directly on the front of the dimmer on the top left, or right below the on/off toggle.
