Shades Support

Using a Pico Wireless or 4-Group RF Remote Control with your Palladiom Wire-Free shades allows you to adjust your shades from anywhere in the room, at the click of a button.  In addition to the ability to raise and lower your shades, you can also use the Preset “Favorite” button on the remote to immediately set the shades to a predetermined level. 

Standalone applications refer to when Caseta, RA2 Select, RadioRA, or HomeWorks are not being used. 

Step 1: Confirm that you have a Lutron Palladiom Wire-Free shade by the button style. 

Palladiom Wire Free Shades - The roller shade features a single LED-equipped control button (the ‘Shade Button’), located on the Electronic Drive Unit on the left- or right-hand side of the headrail. These shades are exclusively battery powered. 

Step 2: Verify standalone operation 

The Shade Button is used to activate and indicate various steps while assigning and programming the shade for compatible handheld or system-based remote control. 

1. Press the Shade Button on your Palladiom Wire-Free Shade and observe for a solid green indicator light.       
     
   a. If the green indicator light remains illuminated, this indicates the shade is ready to be paired, follow step 3.1 to assign a Pico remote control, or step 3.2 to assign a Lutron 4-Group remote control. 
   b. If the green indicator light turns off within one second, this means your Palladiom Wire-Free Shade is connected to a Lutron smart home system. In this case, you must pair your remote to your Palladiom Wire-Free shade through your Lutron system. 
                 1. If a Caséta Smart Bridge or a RA2 Select system is installed, use the Lutron App to program and                         control the shade. 
                 2.If a RadioRA 3 or HomeWorks system is installed, use the Lutron Designer software to program your                  shade. Please visit www.lutron.com/wheretobuy to find a local trained and certified Lutron Dealer.  

Step 3: 

1. For Programming to a Pico Wireless Remotes
   a. Once the indicator light on your Palladiom Wire-Free shade is illuminated solid green, press and hold the “Close” or bottom button on your Pico Wireless Remote for 10 seconds.  
   b. The indicator light on the Palladiom Wire-Free and Pico Wireless Remote will begin to flash green which indicates that pairing was successful. 
   c. Release the “Close” or bottom button on the Pico Wireless Remote. 

      d. Repeat this process again, starting from Step 3.1.a., to pair a new Palladiom Wire-Free to the same remote or to          pair a second Pico Wireless Remote to the same shade. 

2. For Programming to a 4-Group RF Remote Controls 
   
   a. Once the indicator light on your Palladiom Wire-Free shade is illuminated solid green, you must press and hold one of the Shade Group buttons 
   
   b. You should see that the green indicator light on the Palladiom Wire-Free shade will begin to flash which indicates that your 4-Group Remote has been successfully paired 
   
   c. At this point, you can release the “Close” button on the 4-Group Remote. 

         d. Repeat this process again, starting from Step 3.1.a., to pair a new Palladiom Wire-Free shade to the same                     remote or to pair a second Pico Wireless Remote to the same shade.