Skip to main content
Shades Installation How to Wire a Sivoia...

Explore Knowledge Articles

How to Wire a Sivoia QS Triathlon Shade for Power

ka03c000000DdVbAAK
000002915
QSPS-P1-1-35V,QSPS-J-1-50,QSPS-J-1-35V,QSPS-10PNL
roller-shades,exposed-roller-shades,wood-blinds,honeycomb-shades,horizontal-sheer-blinds,tension-shades,drapery-system,kirbé-vertical-drapery-system,tradional-drapery-systems,roman-shades,qs-link-power-supply,sivoia-qs-smart-panel,triathlon-select-battery-powered
sivoiaqs,sivoiaqs-triathlon,contract-motorized-shades,manual-roller-shades,contract-manual-shades,sivoiaqs-wireless,palladiom-wired-shading-system,palladiom-wirefree-shading-system,alena,alena-qs,alena-qs-wireless

Step (1): Confirm that you have a Lutron Triathlon shade by the button style. 

Roller Shades - The Triathlon roller shade features a single LED-equipped control button (the ‘Shade Button’), located on the Electronic Drive Unit on the left or right-hand side of the headrail. 

Honeycomb - The Triathlon Honeycomb shade features a single LED-equipped control button (the ‘Shade Button’), located on the Electronic Drive Unit (EDU), in the headrail near the center of the shade. 

Wood Blinds - The Triathlon Wood Blind features a single LED-equipped control button (the ‘shade button’), located on the Electronic Drive Unit (EDU), in the headrail near the left end of the blind. 

4 Button Shades - If your shade has 4 buttons it is a Sivoia QS, Sivoia QS Wireless, or Palladiom Shade and you should refer to the following link for:   Programming a Lutron Sivoia QS Shade to a Remote 

Step 2: Wiring the Power Supply 

10-Output Panel:  

  1. Run choice of 2-conductor wire to the panel. Connect Black to the COM terminal block and red to the 12 V block. 

 

 

Individual Plug-In Power Supply:  

Step 3: Wiring the Shade 

10-Output Panel: 

1. Cut the 15’ power whip to size from the shade and strip back.  

2. Mate the shade wires up to the 2-conductor house wiring with wire nuts. 

Individual Plug-In Power Supply:  

      1. With the shades power wire routed clear of the shade and secured in a position where it will not interfere with shade movement, connect the individual power supply to the power wire via the barrel plug.   

 

2. Plug the individual power supply into a compatible electrical outlet. The Shade Button LED flashes red/green 3 times when the shade powers up.