Claro Smart Switch for Caseta DVRF-5NS

Documentation

Specification Sheet
Installation Guides
- DVRF-5NS
- Advanced Installation Guide

KNOWLEDGE ARTICLE CONTENTS:

Section (1): Switch Load Ratings
Section (2): Product Installation
Section (3): Product Settings
Section (4): Troubleshooting

Section (1): Switch Load Ratings

MODEL	VOLTAGE	NEUTRAL CONNECTION REQUIRED	WIRE TO 3-WAY SWITCH	LOAD TYPE	MINIMUM LOAD	MAXIMUM LOAD
DVRF-5NS	120V	YES	YES	INC/HALOGEN LED FAN MOTOR ELV MLV	10 WATT 0.1 A 0.1 A 10 WATT 10 WATT	600 WATT 5 AMP 3.0 AMP 600 WATT 600 VA

Section (2): Product Installation

NOTES ON INSTALLATION

Neutral wire required.

Can wire to mechanical 3-way switch in 3 way applications.
Use with Pico remote for 3-way and multi-location dimming (Pico sold separately)
- Up to 10 Pico remotes can be paired with 1 Diva Smart Dimmer

If there is no ground wire in your electrical box, cap off the green wire from the switch. A ground wire connection is not required for this switch to function properly. A ground wire may be required by local electrical code.

APPLICATION	WIRING DIAGRAM	WALK ME THROUGH INSTALL	INSTALLATION VIDEO
1 Location (Single Pole)
2 Locations (3-Way) with a mechanical switch.
2 Locations (3-Way) with Pico Remotes^*
2 Locations (3-Way) with Claro smart accessory switch (Model DVRF-AS)^*
3 or more Locations (4-Way) with Pico Remotes^*
3 or more Locations (4-Way) with Claro smart accessory switch (Model DVRF-AS)^*

*Pico Remotes & Claro smart accessory switches sold separately.

The ADVANCED INSTALLATION GUIDE will guide you through several additional installation topics beyond what was covered in this article.

Section (3): Product Settings

Status LED Indicator Light
Has a white soft glow status LED to indicate load status.

Note:
This can only be disabled/enabled with the use of the Lutron App. Please see the steps to do so below.

Step 1
Tap on the Claro Smart Switch from the Devices area in the Lutron App. Then select "Edit Device".

Step 2
Tap on the "Status LED".

Step 3
Select "On" or "Off" (default is On) and then tap on "Save" in the top right corner of the screen.

Section (4): Troubleshooting

Symptoms	Probable cause and action
Light does not turn on or switch LED does not light up.	• Red and black wires on the switch are reversed. • Light bulb(s) burned out. • Breaker is OFF or tripped. • Light not properly installed. • Wiring error. • FASS on the switch is in the Off position
Light does not respond to Pico remote control.	• The switch failed to pair with Pico remote control; see Pairing the switch and Pico remote control. • The switch is already at the light level the Pico remote control is sending. • The Pico remote control is outside the 30 ft (9 m) operating range. • The Pico remote control battery is low. • The Pico remote control battery is installed incorrectly
Load is Off and the status LED is blinking 4 times, pause, and repeats.	• The switch is in an Over Temperature Protection (OTP) mode. • Ensure Ganging and Derating has been accounted for so that the switch is not overloaded. • Reset the switch by using the FASS, (Front Accessible Service Switch) located under the Off button. Pull out the FASS and push it back in.

Caséta Support

Looking for help? We've got you covered

Explore Knowledge Articles